Tools

Depending on the number of teeth, different results can be achieved with all Optiline Wood Circular Saw Blades, which feature ATB (Alternate Top Bevel) tooth geometry: when equipped with a high tooth count, the blade delivers clean cuts, whereas a low number of teeth guarantees solid and efficient cuts.

• Perfectly suited to cutting parquet, laminate, expoxy, glass fibre and cement-bonded fibre boards
• Very fine cut in plastic and non-ferrous metals
• Base Blade, dimensionally stable SK5 steel, hardened (>40 HRC)
• Tungsten carbide teeth
• Safe cuts thanks to negative (-5°) trapezoidal/flat teeth made of high-quality tungsten carbide
• Body and expansion slots lower vibrations, dampen noise and reduce heat development

• For sheet metal 10-16 gauge, thin metals 1/16 In. to 1/8 In. thick (ferrous and non-ferrous)
• 17-24 TPI progressive tooth design for smooth cuts in various thicknesses
• High-speed steel construction for maximum life in straight cuts
• 3-5/8 In. overall length, 2-5/8 In. working length
• Proper lubricant is recommended when cutting metal
• 5 piece pack

• Twin drill bit made of high speed steel

• Manufactured to DIN338

• Right-hand cutting twist drill bit, Type N, 135° drill bit tip, split point manufactured to DIN 1412 C, diameter tolerance h 8

• Shank equal to drill bit diameter

• Two-cutter, cylindrical, two flutes

• Suitable for alloyed and non-alloyed steel up to a tensile strength of 900 N/mm², cast steel, cast iron, sintered iron, malleable cast iron, non-ferrous metals and hard plastics

• Precision ground - enables up to 40% faster drilling rate and up to 50% lower feed pressure than standard-ground HSS drill bits with a chisel edge

• Self centering split point drill tip means there is no need to pre-punch or pilot drill up to 10mm diameter

• Note: Use the universal cutting oil (2 607 001 409) when working with HSS-G metal drill bits

• Pack of 10

• Maximum speed, power & top level user protection
• Full power & high performance due to new motor with +100W, Constant electronics for constant power& soft start with starting current limitation
• Longer endurance because of up to 1,7 times longer carbon brush lifetime, new stronger motor, direct cooling, and motor overload protection
• Superior user protection with KickBack Stop, AVH & Restart protection

• Powerful 9.6 AMP motor for various cutting applications
• Cuts up to 1-3/8""
• Compact design at only 8-5/8"" long and weighs only 6.5 lbs. for less operator fatigue
• High power-to-weight ratio with 13,000 RPM
• Easy to adjust depth gauge for precision cutting
• Lock-off button helps prevent accidental start-ups
• Flat rear side of motor housing allows for easy blade changes
• Powerful cutting in stone, masonry, tile and concrete
• Double insulated
• Makita built motor delivers 12 AMPS for various cutting applications
• Increased 1-3/8"cutting capacity
• More compact design at only 8-5/8"long and weights only 5.9 lbs for less operator fatigue
• High power to weight 13,000 RPM
• Easy to adjust depth gauge for precision cutting

The Nedo inclinometer level is easy to operate, rugged and splash-proof.