• Bosch 2608602535 Diamond Cutting Disc Standard for Ceramic

• Suitable for all soft and hard woods, even wet wood
• Ideal for use in ancillary building trade, for joiners and roofers
• Can be used in all drills with 13mm chuck
• For through-holes, pre drilling for rafter nails and for deep dowel holes
• Precision ground for accurate dimensional stability when drilling
• Fast drilling rate due to optimised flute geometry
• High break resistance, fine surface finish

• Suitable for all soft and hard woods, even wet wood
• Ideal for use in ancillary building trade, for joiners and roofers
• Can be used in all drills with 13mm chuck
• For through-holes, pre drilling for rafter nails and for deep dowel holes
• Precision ground for accurate dimensional stability when drilling
• Fast drilling rate due to optimised flute geometry
• High break resistance, fine surface finish

• Twin drill bit made of high speed steel
• Manufactured to DIN338
• Right-hand cutting twist drill bit, Type N, 135° drill bit tip, split point manufactured to DIN 1412 C, diameter tolerance h 8
• Shank equal to drill bit diameter
• Two-cutter, cylindrical, two flutes
• Suitable for alloyed and non-alloyed steel up to a tensile strength of 900 N/mm², cast steel, cast iron, sintered iron, malleable cast iron, non-ferrous metals and hard plastics
• Precision ground - enables up to 40% faster drilling rate and up to 50% lower feed pressure than standard-ground HSS drill bits with a chisel edge
• Self centering split point drill tip means there is no need to pre-punch or pilot drill up to 10mm diameter
• Note: Use the universal cutting oil (2 608 595 081) when working with HSS-G metal drill bits

• Metal Grinding Disc
• Depressed Centre
• A 30 T BF specification
• Appropriate for hand-held angle grinders
• Maximum circumferential speed 80 m/s (depending on rpm and disc diameter)

• Metal/Stone cutting disc
• Depressed centre
• For stone for high requirements
• Appropriate for hand-held angle grinders
• Maximum circumferential speed 80 m/s (depending on rpm and disc diameter)

• Perfectly suited to cutting parquet, laminate, expoxy, glass fibre and cement-bonded fibre boards
• Very fine cut in plastic and non-ferrous metals
• Base Blade, dimensionally stable SK5 steel, hardened (>40 HRC)
• Tungsten carbide teeth
• Safe cuts thanks to negative (-5°) trapezoidal/flat teeth made of high-quality tungsten carbide
• Body and expansion slots lower vibrations, dampen noise and reduce heat development

Depending on the number of teeth, different results can be achieved with all Optiline Wood Circular Saw Blades, which feature ATB (Alternate Top Bevel) tooth geometry: when equipped with a high tooth count, the blade delivers clean cuts, whereas a low number of teeth guarantees solid and efficient cuts.

• Robust design with sturdy magnesium housing for high reliability in every job
• Compact tool shape also enables work in hard-to-reach areas
• Long lifetime of wear parts for more economical working

• Slim design for precise positioning at the fastening point
• No blank firing thanks to “wood protection system” for absolutely clean working
• Rubber-coated tip prevents damage to valuable surfaces

• Slim design for precise positioning at the fastening point
• 2Wood Protection System means no blank firing, thus ensuring absolutely clean work
• 3Rubber-coated tip prevents damage to valuable surfaces

• Robust design with sturdy magnesium housing for high reliability in every job
• Compact tool shape also enables work in hard-to-reach areas
• Long lifetime of wear parts for more economical working