• For sheet metal 10-16 gauge, thin metals 1/16 In. to 1/8 In. thick (ferrous and non-ferrous)
• 17-24 TPI progressive tooth design for smooth cuts in various thicknesses
• High-speed steel construction for maximum life in straight cuts
• 3-5/8 In. overall length, 2-5/8 In. working length
• Proper lubricant is recommended when cutting metal
• 5 piece pack

• Perfectly suited to cutting parquet, laminate, expoxy, glass fibre and cement-bonded fibre boards
• Very fine cut in plastic and non-ferrous metals
• Base Blade, dimensionally stable SK5 steel, hardened (>40 HRC)
• Tungsten carbide teeth
• Safe cuts thanks to negative (-5°) trapezoidal/flat teeth made of high-quality tungsten carbide
• Body and expansion slots lower vibrations, dampen noise and reduce heat development

Depending on the number of teeth, different results can be achieved with all Optiline Wood Circular Saw Blades, which feature ATB (Alternate Top Bevel) tooth geometry: when equipped with a high tooth count, the blade delivers clean cuts, whereas a low number of teeth guarantees solid and efficient cuts.

• And occasional use in hardwood
• Suited to cutting parquet, laminate, epoxy
• Fine cut in plastic and non-ferrous metals
• Body and expansion slots lower vibrations,
• Dampen noise and reduce heat development

• Drill bits are cutting tools used to create cylindrical holes.
• Bits are usually connected to a mechanism, which rotates them and provides torque and axial force to create the hole.
• It is suitable for concrete, brick wall and metal drilling.

• Drill bits are cutting tools used to create cylindrical holes.
• Bits are usually connected to a mechanism, which rotates them and provides torque and axial force to create the hole.
• It is suitable for concrete, brick wall and metal drilling.

• Bosch 2608602535 Diamond Cutting Disc Standard for Ceramic

• Suitable for all soft and hard woods, even wet wood
• Ideal for use in ancillary building trade, for joiners and roofers
• Can be used in all drills with 13mm chuck
• For through-holes, pre drilling for rafter nails and for deep dowel holes
• Precision ground for accurate dimensional stability when drilling
• Fast drilling rate due to optimised flute geometry
• High break resistance, fine surface finish

• Suitable for all soft and hard woods, even wet wood
• Ideal for use in ancillary building trade, for joiners and roofers
• Can be used in all drills with 13mm chuck
• For through-holes, pre drilling for rafter nails and for deep dowel holes
• Precision ground for accurate dimensional stability when drilling
• Fast drilling rate due to optimised flute geometry
• High break resistance, fine surface finish

• Option for Shamal - red or Nuair - Blue

• Fitted with a 1.2 Metre power cord and fused Plug.
• Capacity 255/9 L/min with a maximum working pressure at 10 bar (145 psi). Dimension - 800x390x750
• And come within warranty according terms of use.

Important - there is also the ABAC brand for the same model at an additional cost of 20%