Product Description

This is an authentic OEM sourced replacement piston ring set which is specially designed for use with Honda engines commonly installed on lawn and garden equipment. The purpose of these ring is to provide a tight seal between walls of the cylinder and the piston. A worn or broken piston ring will allow combustion gasses to escape the seal and enter the crankcase, causing low compression and a loss of power. If compression is reduced significantly, the engine will not run at all. 

• Powerful 2000 watt motor for breakthroughs in reinforced concrete up to 180 mm
• Long lifetime due to robust design and gearbox with oil-bath lubrication
• Wet and dry application; both hand-held and stand-mounted 

• High power reserves, even in hard and thick beams, due to powerful and overload-capable 780-watt motor
• Extremely robust and bend-resistant sole plate for the toughest jobs
• High cutting precision due to new saw blade clamping system
• Tool-free saw blade clamping system for easy and fast saw blade changes
• Ergonomic grip area with softgrip surfaces for a high level of work comfort
• 4-stage pendulum action for fine through to coarse cuts
• Electronic speed preselection

• Metal Grinding Disc
• Depressed Centre
• A 30 T BF specification
• Appropriate for hand-held angle grinders
• Maximum circumferential speed 80 m/s (depending on rpm and disc diameter)

• Twin drill bit made of high speed steel
• Manufactured to DIN338
• Right-hand cutting twist drill bit, Type N, 135° drill bit tip, split point manufactured to DIN 1412 C, diameter tolerance h 8
• Shank equal to drill bit diameter
• Two-cutter, cylindrical, two flutes
• Suitable for alloyed and non-alloyed steel up to a tensile strength of 900 N/mm², cast steel, cast iron, sintered iron, malleable cast iron, non-ferrous metals and hard plastics
• Precision ground - enables up to 40% faster drilling rate and up to 50% lower feed pressure than standard-ground HSS drill bits with a chisel edge
• Self centering split point drill tip means there is no need to pre-punch or pilot drill up to 10mm diameter
• Note: Use the universal cutting oil (2 608 595 081) when working with HSS-G metal drill bits

• Suitable for all soft and hard woods, even wet wood
• Ideal for use in ancillary building trade, for joiners and roofers
• Can be used in all drills with 13mm chuck
• For through-holes, pre drilling for rafter nails and for deep dowel holes
• Precision ground for accurate dimensional stability when drilling
• Fast drilling rate due to optimised flute geometry
• High break resistance, fine surface finish

• Suitable for all soft and hard woods, even wet wood
• Ideal for use in ancillary building trade, for joiners and roofers
• Can be used in all drills with 13mm chuck
• For through-holes, pre drilling for rafter nails and for deep dowel holes
• Precision ground for accurate dimensional stability when drilling
• Fast drilling rate due to optimised flute geometry
• High break resistance, fine surface finish

• Bosch 2608602535 Diamond Cutting Disc Standard for Ceramic

• The basic diamond cutting disc that is a problem solver for concrete
• Laser-welded diamond cutting disc
• Safety product according to EN norm 13236
• With reduction ring 25.4/20mm

• The low-cost solution in all building materials with clean cut edges.
• Sintered cutting rim.